Lego Mindstorms EV3 Intro ===== This is the buildroot basic board support for the Lego Mindstorms EV3 programmable brick. The Lego Mindstorms EV3 brick comprises a Texas Instruments AM1808 SoC, with an ARM 926EJ-S main processor running at 300 MHz. See: - https://en.wikipedia.org/wiki/Lego_Mindstorms_EV3 - http://www.lego.com/en-us/mindstorms/products/ev3/31313-mindstorms-ev3/ - http://www.ti.com/product/am1808 How it works ============ Boot process : -------------- The EV3 boots from an EEPROM. This loads whatever is on the built-in 16MB flash (usually U-Boot) and runs it. The U-Boot from the official LEGO firmware and mainline U-Boot will attempt to boot a Linux kernel from the external µSD card. It will try to load a uImage (and optional boot.scr) from the first µSD card partition, which must be formatted with a FAT filesystem. If no µSD is found or it does not contain a uImage file, then the EV3 will boot the uImage from the built-in 16MB flash. How to build it =============== Configure Buildroot ------------------- The lego_ev3_defconfig configuration provides basic support to boot on the Lego Mindstorms EV3 programmable brick: $ make lego_ev3_defconfig Build everything ---------------- Note: you will need to have access to the network, since Buildroot will download the packages' sources. $ make Result of the build ------------------- After building, you should obtain this tree: output/images/ ├── boot.vfat ├── flash.bin ├── rootfs.ext2 ├── rootfs.ext3 -> rootfs.ext2 ├── rootfs.squashfs ├── sdcard.img ├── u-boot.bin ├── uImage -> uImage.da850-lego-ev3 └── uImage.da850-lego-ev3 Installation ============ You can use either flash.bin or the sdcard.img. To load flash.bin, use the official Lego Mindstorms EV3 programming software firmware update tool to load the image. To use sdcard.img, use a disk writing tool such as Etcher or dd to write the image to the µSD card. Finish ====== To have a serial console, you will need a proper USB to Lego serial port adapter plugged into the EV3 sensors port 1. See: - http://botbench.com/blog/2013/08/15/ev3-creating-console-cable/ - http://botbench.com/blog/2013/08/05/mindsensors-ev3-usb-console-adapter/ The serial port config to use is 115200/8-N-1.